186
Configuring Switch-Based Authentication
Additional References
<output truncated>
You can remove this self-signed certificate by disabling the secure HTTP server and entering the no crypto pki trustpoint
TP-self-signed-30890755072 global configuration command. If you later reenable a secure HTTP server, a new
self-signed certificate is generated.
Verifying Secure HTTP Connection: Example
To verify the secure HTTP connection by using a Web browser, enter https://URL, where the URL is the IP address or
hostname of the server switch. If you configure a port other than the default port, you must also specify the port number
after the URL. For example:
https://209.165.129:1026
or
https://host.domain.com:1026
Additional References
The following sections provide references related to switch administration:
To Next Page
Loading...
