Cisco IE 4000 Software Configuration Guide

502
Configuring CDP
Additional References
Enabling CDP: Examples
This example shows how to enable CDP on a port when it has been disabled:
Switch# configure terminal
Switch(config)# interface GigabitEthernet1/17
Switch(config-if)# cdp enable
Switch(config-if)# end
Note: Voice VLAN is not counted against port security when CDP is disabled on the switch interface.
This example shows how to enable CDP if it has been disabled:
Switch# configure terminal
Switch(config)# cdp run
Switch(config)# end
Additional References
The following sections provide references related to switch administration:
Related Documents
Standards
MIBs
RFCs
Related Topic Document Title
Cisco IOS basic commands
Cisco IOS system management commands
Cisco IOS Configuration Fundamentals Command Reference
Switch cluster configuration Configuring Switch Clusters, page 91
Standards Title
No new or modified standards are supported by this
feature, and support for existing standards has not
been modified by this feature.
—
MIBs MIBs Link
— To locate and download MIBs using Cisco IOS XR software, use the
Cisco MIB Locator found at the following URL and choose a platform
under the Cisco Access Products menu:
http://cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
RFCs Title
No new or modified RFCs are supported by this
feature, and support for existing RFCs has not been
modified by this feature.
—

Cisco IE 4000 Specifications

General

Product Type	Switch
Form Factor	DIN Rail Mountable
MAC Address Table Size	8000
Jumbo Frame Support	9216 bytes
Operating Temperature	-40°C to 70°C
Mean Time Between Failures (MTBF)	Over 500, 000 hours
Memory	256 MB DRAM
Mounting	DIN Rail, Wall
Certifications	EN 50121-4
Ports	8 x 10/100Base-TX Ethernet Ports