Cisco IE 4000 Software Configuration Guide

543
Configuring SNMP
Additional References
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server inform retries 0
Assigning a String to SNMP: Example
This example shows how to assign the string comaccess to SNMP, to allow read-only access, and to specify that IP
access list 4 can use the community string to gain access to the switch SNMP agent:
Switch(config)# snmp-server community comaccess ro 4
Additional References
The following sections provide references related to switch administration:

Cisco IE 4000 Specifications

General

Product Type	Switch
Form Factor	DIN Rail Mountable
MAC Address Table Size	8000
Jumbo Frame Support	9216 bytes
Operating Temperature	-40°C to 70°C
Mean Time Between Failures (MTBF)	Over 500, 000 hours
Memory	256 MB DRAM
Mounting	DIN Rail, Wall
Certifications	EN 50121-4
Ports	8 x 10/100Base-TX Ethernet Ports