Cisco IE-5000 User Manual

948
Configuring IPv6 Unicast Routing
Configuring IPv6
Switch(config-if)# ipv6 rip cisco enable
Configuring OSPF for IPv6
You can customize OSPF for IPv6 for your network. However, the defaults are set to meet the requirements of most
customers and features.
Be careful when changing the defaults for IPv6 commands. Doing so might adversely affect OSPF for the IPv6 network.
BEFORE YOU BEGIN
Before you enable IPv6 OSPF on an interface, you must:
 Enable routing by using the ip routing global configuration command.
 Enable the forwarding of IPv6 packets by using the ipv6 unicast-routing global configuration command.
 Enable IPv6 on Layer 3 interfaces on which you are enabling IPv6 OSPF.

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes