Cisco IE-5000 User Manual

742
Configuring MSDP
Configuring MSDP
Controlling Source Information that Your Switch Forwards
By default, the switch forwards all SA messages it receives to all its MSDP peers. However, you can prevent outgoing
messages from being forwarded to a peer by using a filter or by setting a time-to-live (TTL) value. These methods are
described in the next sections.
Using a Filter
By creating a filter, you can perform one of these actions:
 Filter all source/group pairs
 Specify an IP extended access list to pass only certain source/group pairs
 Filter based on match criteria in a route map
Follow this procedure to apply a filter. This procedure is optional.
BEFORE YOU BEGIN
For best practice information related to configuring MSDP SA message filters, see the Multicast Source Discovery
Protocol SA Filter Recommendations tech note.

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes