761
Configuring IPv6 MLD Snooping
Configuring IPv6 MLD Snooping
EXAMPLE
This example shows how to enable MLD Immediate Leave on VLAN 130:
Switch# configure terminal
Switch(config)# ipv6 mld snooping vlan 130 immediate-leave
Switch(config)# exit
Configuring MLD Snooping Queries
When Immediate Leave is not enabled and a port receives an MLD Done message, the switch generates MASQs on the
port and sends them to the IPv6 multicast address for which the Done message was sent. You can optionally configure
the number of MASQs that are sent and the length of time the switch waits for a response before deleting the port from
the multicast group.
To Next Page
Loading...
