Cisco IE-5000 User Manual

891
Configuring IP Unicast Routing
Configuring BFD
DETAILED STEPS
To disable BGP BFD, enter the no neighbor ip-address fall-over bfd router configuration command.
Configuring BFD for EIGRP
When you start BFD sessions for EIGRP, EIGRP must be running on all participating devices.You can enable BFD support
for EIGRP by globally enabling it on all EIGRP interfaces or by enabling it on one or more interfaces.
BEFORE YOU BEGIN
 Configure BFD parameters on the interface as described in the Configuring BFD Session Parameters on an Interface,
page 886.
 Configure EIGRP as described in the Configuring EIGRP, page 838.
Command Purpose
1. configure terminal Enter global configuration mode.
2. router bgp as-tag Specify a BGP autonomous system, and enter router configuration
mode.
3. neighbor ip-address fall-over
bfd
Enable BFD support for fallover on the BFD neighbor.
4. end Return to privileged EXEC mode.
5. show bfd neighbors [detail]
>
show ip bgp neighbor
Verify the configuration.
Display information about BGP connections to neighbors.
6. copy running-config
startup-config
(Optional) Save your entries in the configuration file.

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes