985
Configuring Enhanced Object Tracking
Monitoring Enhanced Object Tracking
For configuration examples, see this URL:
http://www.cisco.com/en/US/docs/ios/12_3/12_3x/12_3xe/feature/guide/dbackupx.html
Monitoring Enhanced Object Tracking
Use the following privileged EXEC or User EXEC commands ito display enhanced object tracking information.
9. { ip route prefix mask {ip-address |
interface-id [ip-address]} [distance] [name]
[permanent | track track-number] [tag tag]
For static routing networks only. Establish static routes.
Entering track track-number specifies that the static route is installed
only if the configured track object is up.
10. end Return to privileged EXEC mode.
11. show ip route track table Display information about the IP route track table.
12. copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
show ip route track table Display information about the IP route track table.
show track [object-number] Display information about the all tracking lists or the
specified list.
show track brief Display a single line of tracking information output.
show track interface [brief] Display information about tracked interface objects.
show track ip [object-number] [brief] route Display information about tracked IP-route objects.
show track resolution Display the resolution of tracked parameters.
show track timers Display tracked polling interval timers.
To Next Page
Loading...
Need help?
General
