Cisco Mesh Access Points User Manual

config {802.11a | 802.11b} disable network
Step 2
Globally enable or disable beamforming on your 802.11a or 802.11g network by entering this command:
config {802.11a | 802.11b} beamforming global {enable | disable}
The default value is disabled.
After you enable beamforming on the network, it is automatically enabled for all the radios applicable to that
network type.
Note
Step 3
Override the global configuration and enable or disable beamforming for a specific access point by entering this command:
config {802.11a | 802.11b} beamforming ap Cisco_AP {enable | disable}
The default value is disabled if beamforming is disabled on the network and enabled if beamforming is enabled on the
network.
Step 4
Reenable the network by entering this command:
config {802.11a | 802.11b} enable network
Step 5
Save your changes by entering this command:
save config
Step 6
See the beamforming status for your network by entering this command:
show {802.11a | 802.11b}
Information similar to the following appears:
802.11a Network.................................. Enabled
11nSupport....................................... Enabled
802.11a Low Band........................... Enabled
802.11a Mid Band........................... Enabled
802.11a High Band.......................... Enabled
...
Pico-Cell-V2 Status.............................. Disabled
TI Threshold..................................... -50
Legacy Tx Beamforming setting................. Enabled
Step 7
See the beamforming status for a specific access point by entering this command:
show ap config {802.11a | 802.11b} Cisco_AP
Information similar to the following appears:
Cisco AP Identifier.............................. 14
Cisco AP Name.................................... 1250-1
Country code..................................... US - United States
Regulatory Domain allowed by Country............. 802.11bg:-A 802.11a:-A
...
Phy OFDM parameters
Configuration ............................. AUTOMATIC
Current Channel ........................... 149
Extension Channel ......................... NONE
Channel Width.............................. 20 Mhz
Allowed Channel List....................... 36,40,44,48,52,56,60,64,100,
......................................... 104,108,112,116,132,136,140,
......................................... 149,153,157,161,165
TI Threshold .............................. -50
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
OL-27593-01 57
Design Considerations
Configuring ClientLink (CLI)

Cisco Mesh Access Points Specifications

General

Brand	Cisco
Model	Mesh Access Points
Category	Wireless Access Point
Language	English