D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 100
Cisco TelePresence MX700 and MX800
API Reference Guide
Camera commands
xCommand Camera PositionReset
Reset the camera position to default position.
Requires user role: USER
USAGE:
xCommand Camera PositionReset [A xis: Axis] CameraId: Ca meraId
where
Axis: All/Focus/PanTilt/Zoom
Select which motor to reset. If not specified all are reset.
CameraId: Integer (1..7)
The ID of the camera preset you want to reset.
xCommand Camera Preset Activate
Activate one of the stored camera presets.
Note that the xCommand Camera Preset commands applies to an individual camera. This is
in contrast to the xCommand Preset commands where a single preset covers ALL connected
cameras plus the Video Input switcher settings.
Requires user role: USER
USAGE:
xCommand Camera Preset Activate PresetId: PresetId
where
PresetId: Integer (1..35)
The ID of the camera preset you want to activate.
xCommand Camera Preset ActivateDefaultPosition
Sets the cameras to their default position, if one is defined. The default position is defined
by xCommand Camera Preset Store or by xCommand Camera Preset Edit. Only one default
position can be defined per camera.
Requires user role: USER
USAGE:
xCommand Camera Preset ActivateDefaultPosition [Ca m eraId: Ca meraId]
where
CameraId: Integer (1..7)
The ID of the camera preset you want to activate. If CameraId is not specified, all
cameras will be set in their respective default position, if one is defined.
To Next Page
Loading...
Need help?
General
