D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 48
Cisco TelePresence MX700 and MX800
API Reference Guide
Conference configuration
xConfiguration Conference AutoAnswer Mode
Define the auto answer mode. Use the Conference AutoAnswer Delay setting if you want
the system to wait a number of seconds before answering the call, and use the Conference
AutoAnswer Mute setting if you want your microphone to be muted when the call is answered.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration Conference AutoAnswer Mode: Mode
where
Mode
: Off/On
Off: You must answer incomming calls manually by tapping Answer on the Touch
controller.
On: The system automatically answers incoming calls, except if you are already in a
call. You must always answer or decline incoming calls manually when you are already
engaged in a call.
xConfiguration Conference AutoAnswer Mute
Define if the microphone shall be muted when an incoming call is automatically answered.
Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration Conference AutoAnswer Mute: Mute
where
Mute
: Off/On
Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.
xConfiguration Conference AutoAnswer Delay
Define how long (in seconds) an incoming call has to wait before it is answered automatically by
the system. Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Default value: 0
USAGE:
xConfiguration Conference AutoAnswer Delay: Delay
where
Delay
: Integer (0..50)
The auto answer delay (seconds).
xConfiguration Conference DefaultCall Protocol
Define the Default Call Protocol to be used when placing calls from the system.
Requires user role: ADMIN
Default value: Auto
USAGE:
xConfiguration Conference DefaultCall Protocol: Protocol
where
Protocol
: Auto/H323/Sip/H320
Auto: Enables auto-selection of the call protocol based on which protocols are available.
If multiple protocols are available, the order of priority is: 1) SIP; 2) H323; 3) H320. If the
system cannot register, or the call protocol is not enabled, the auto-selection chooses
H323.
H323: All calls are set up as H.323 calls.
Sip: All calls are set up as SIP calls.
H320: All calls are set up as H.320 calls (only applicable if connected to Cisco
TelePresence ISDN Link).
To Next Page
Loading...
Need help?
General
