Cisco TelePresence MX200 G2 Reference Guide

D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 88
Cisco TelePresence MX700 and MX800
API Reference Guide
xConfiguration Video Selfview OnCall Mode
This setting is used to switch on self-view for a short while when setting up a call. The Video
Selfview OnCall Duration setting determines for how long it remains on. This applies when self-
view in general is switched off.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Video Selfview OnCall Mode: Mode
where
Mode : Off/On
Off: self-view is not shown automatically during call setup.
On: self-view is shown automatically during call setup.
xConfiguration Video Selfview OnCall Duration
This setting only has an effect when the Video Selfview OnCall Mode setting is switched On. In
this case, the number of seconds set here determines for how long self-view is shown before it
is automatically switched off.
Requires user role: ADMIN
Default value: 10
USAGE:
xConfiguration Video Selfview OnCall Duration: Durat ion
where
Duration : Integer (1..60)
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus

xConfiguration

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30