Cisco TelePresence MX200 G2 Reference Guide

D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 137
Cisco TelePresence MX700 and MX800
API Reference Guide
xStatus Audio Output LocalOutput [n] Connector [n]
Lists the connectors that are attached to the local output.
You can run the command xStatus Audio Output LocalOutput to find the identity [n] of the
output.
Value space of the result returned:
String
Example:
xStatus Audio Output LocalOutput 4 Connector
*s Audio Output LocalOutput 4 Connector: "Line.1"
** end
xStatus Audio Output LocalOutput [n] Input [n] Gain
Shows the gain (dB) on the input, when it is connected to the local output. Range from -54 dB
to 15 dB, where -54 dB equals Off.
You can run the command xStatus Audio Output LocalOutput to find the identity [n] of the
output and input.
Value space of the result returned:
-54..15
Example:
xStatus Audio Output LocalOutput 4 Input 2 Gain
*s Audio Output LocalOutput 4 Input 2 Gain: 0
** end
xStatus Audio Output LocalOutput [n] Loudspeaker
Shows the Loudspeaker mode on the local output. If one or more of the output connectors that
are attached to the local output are connected to a loudspeaker, then this signal should be a
reference signal to the echo canceler and Loudspeaker should be set to On.
You can run the command xStatus Audio Output LocalOutput to find the identity [n] of the
output.
Value space of the result returned:
On/Off
Example:
xStatus Audio Output LocalOutput 4 Loudspeaker
*s Audio Output LocalOutput 4 Loudspeaker: "Off"
** end
xStatus Audio Output LocalOutput [n] Name
Shows the name of the local output.
You can run the command xStatus Audio Output LocalOutput to find the identity [n] of the
output.
Value space of the result returned:
String
Example:
xStatus Audio Output LocalOutput 4 Name
*s Audio Output LocalOutput 4 Name: "MyLocalOutput1"
** end
xStatus Audio Output LocalOutput [n] VolumeControlled
Shows whether this output’s volume is controlled by global audio control (Off), or if it is at the
level defined with xCommand Audio Volume Set (On).
Value space of the result returned:
String
Example:
xStatus Audio Output LocalOutput 5 VolumeControlled
*s Audio Output LocalOutput 5 VolumeControlled: "On"
** end
xStatus Audio Output RemoteOutput [n] CallId
Shows the CallId for the remote audio output.
You can run the command xStatus Audio Output RemoteOutput to find the identity [n] of the
output.
Value space of the result returned:
1..65534
Example:
xStatus Audio Output RemoteOutput 9 CallId
*s Audio Output RemoteOutput 9 CallId: 28
** end
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus

xStatus

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30