D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 124
Cisco TelePresence MX700 and MX800
API Reference Guide
xCommand UserInterface Message TextLine Display
Display a text line on screen. Optionally you can place the text line at a specified location and
for a specified duration of time (in seconds).
NOTE: If Duration is not set, the command must be followed by xCommand Message TextLine
Clear.
Requires user role: ADMIN
USAGE:
xCommand UserInterface Message TextLine Display Text: "Text" [X: X] [Y: Y]
[Duration: Duration]
where
Text: String (0, 140)
Enter th
e text lin
e to be dis
playe
d. The <p> and <br> H
TM
L tags w
ill res
ult in li
ne brea
ks
as normal; any other tags will appear as plain text.
X: Integer (1..10000)
Enter the X-coordinate (horizontal) on screen. X=0 is in the upper left corner.
Y: Integer (1..10000)
Enter the Y-coordinate (vertical) on screen. Y=0 is in the upper left corner.
Duration: Integer (0..3600)
Set how long (in seconds) the text line is to be displayed on the screen. If set to 0 (zero)
the text line is displayed until a xCommand Message TextLine Clear command has been
sent.
UserManagement commands
xCommand UserManagement RemoteSupportUser Create
Create a remote support user passphrase that Technical Assistance Center (TAC) can use to
access the system for troubleshooting.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Create [ExpiryDays: ExpiryDays]
where
ExpiryDays: Integer (1..31)
Define the duration for the passphrase validity. Default is 7 days.
xCommand UserManagement RemoteSupportUser Delete
Delete the remote support user created with the command xCommand UserManagement
RemoteSupportUser Create.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Delete
xCommand UserManagement RemoteSupportUser DisablePermanently
Disable the creation of new remote support users. To enable the remote support user again you
must factory reset your system.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser DisablePermanently Confirm: Confirm
where
Confirm: Yes
To Next Page
Loading...
Need help?
General
