Cisco TelePresence MX200 G2 Reference Guide

D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 64
Cisco TelePresence MX700 and MX800
API Reference Guide
xConfiguration NetworkServices HTTP Mode
Define whether or not to allow access to the video system using the HTTP or HTTPS (HTTP
Secure) protocols. Note that the video system's web interface use HTTP or HTTPS. If this
setting is switched Off, you cannot use the web interface.
If you need extra security (encryption and decryption of requests, and pages that are returned
by the web server), allow only HTTPS.
Requires user role: ADMIN
Default value: HTTP+HTTPS
USAGE:
xConfiguration NetworkServices HTTP Mod e: Mod e
where
Mode : Off/HTTP+HTTPS/HTTPS
Off: Access to the video system not allowed via HTTP or HTTPS.
HTTP+HTTPS: Access to the video system allowed via both HTTP and HTTPS.
HTTPS: Access to the video system allowed via HTTPS, but not via HTTP.
xConfiguration NetworkServices NTP Mode
The Network Time Protocol (NTP) is used to synchronize the system's time and date to a refer-
ence time server. The time server will be queried regularly for time updates.
Requires user role: ADMIN
Default value: Auto
USAGE:
xConfiguration NetworkServices NTP Mo de: Mode
where
Mode : Auto/Manual/Off
Auto: The system will use an NTP server for time reference. As default, the server
address will be obtained from the network's DHCP server. If a DHCP server is not used,
or if the DHCP server does not provide an NTP server address, the NTP server address
that is specified in the NetworkServices NTP Server [n] Address setting will be used.
Manual: The system will use the NTP server that is specified in the NetworkServices
NTP Server [n] Address setting for time reference.
Off: The system will not use an NTP server. The NetworkServices NTP Server [n]
Address setting will be ignored.
xConfiguration NetworkServices NTP Server [1..3] Address
The address of the NTP server that will be used when NetworkServices NTP Mode is set to
Manual, and when NetworkServices NTP Mode is set to Auto and no address is supplied by a
DHCP server.
Requires user role: ADMIN
Default value: 0.tandberg.pool.ntp.org
USAGE:
xConfiguration NetworkServices NTP Server n Ad d ress: "Address"
where
Address : String (0, 64)
A valid IPv4 address, IPv6 address or DNS name.
xConfiguration NetworkServices SIP Mode
Define whether the system should be able to place and receive SIP calls or not.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration NetworkServices SIP Mode: Mode
where
Mode : Off/On
Off: Disable the possibility to place and receive SIP calls.
On: Enable the possibility to place and receive SIP calls (default).
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus

xConfiguration

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30