Cisco TelePresence MX200 G2 Reference Guide

D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 76
Cisco TelePresence MX700 and MX800
API Reference Guide
xConfiguration SIP URI
The SIP URI (Uniform Resource Identifier) is the address that is used to identify the video
system. The URI is registered and used by the SIP services to route inbound calls to the system.
The SIP URI syntax is defined in RFC 3261.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration SIP U R I: "URI"
where
URI : String (0, 255)
An address (URI) that is compliant with the SIP URI syntax.
Standby configuration
xConfiguration Standby Control
Define whether the system should go into standby mode or not.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Standby Control: Control
where
Control : Off/On
Off: The system will not enter standby mode.
On: The system will enter standby mode when the Standby Delay has timed out.
Requires the Standby Delay to be set to an appropriate value.
xConfiguration Standby Delay
Define how long (in minutes) the system shall be in idle mode before it goes into standby mode.
Requires the Standby Control to be enabled.
Requires user role: ADMIN
Default value: 10
USAGE:
xConfiguration Standby Delay: Delay
where
Delay : Integer (1..480)
Set the standby delay (minutes).
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus

xConfiguration

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30