Cisco TelePresence MX200 G2 Reference Guide

D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 62
Cisco TelePresence MX700 and MX800
API Reference Guide
xConfiguration Network [1] QoS Diffserv NTP
This setting will only take effect if Network QoS Mode is set to Diffserv.
Define which priority NTP packets should have in the IP network.
The priority for the packets ranges from 0 to 63 - the higher the number, the higher the prior-
ity. The recommended value for NTP is 0, which means best effort. If in doubt, contact your
network administrator.
The priority set here might be overridden when packets are leaving the network controlled by
the local network administrator.
Requires user role: ADMIN
Default value: 0
USAGE:
xConfiguration Network n QoS Diffserv NTP: NTP
where
NTP : Integer (0..63)
Set the priority of the NTP packets in the IP network - the higher the number, the higher
the priority. The default value is 0 (best effort).
xConfiguration Network [1] RemoteAccess Allow
Define which IP addresses (IPv4/IPv6) are allowed for remote access to the codec from SSH/
Telnet/HTTP/HTTPS. Multiple IP addresses are separated by a white space.
A network mask (IP range) is specified by <ip address>/N, where N is 1-32 for IPv4, and N is
1-128 for IPv6. The /N is a common indication of a network mask where the first N bits are set.
Thus 192.168.0.0/24 would match any address starting with 192.168.0, since these are the first
24 bits in the address.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration Network n RemoteAccess Allow: "Allow"
where
n : Index that identifies the network. Range: 1..1
Allow : String (0, 255)
A valid IPv4 address or IPv6 address.
xConfiguration Network [1] Speed
Define the Ethernet link speed.
Requires user role: ADMIN
Default value: Auto
USAGE:
xConfiguration Network n Speed: Speed
where
n : Index that identifies the network. Range: 1..1
Speed : Auto/10half/10full/100half/100full/1000full
Auto: Autonegotiate link speed.
10half: Force link to 10 Mbps half-duplex.
10full: Force link to 10 Mbps full-duplex.
100half: Force link to 100 Mbps half-duplex.
100full: Force link to 100 Mbps full-duplex.
1000full: Force link to 1 Gbps full-duplex.
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus

xConfiguration

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30