Cisco TelePresence MX200 G2 Reference Guide

D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 119
Cisco TelePresence MX700 and MX800
API Reference Guide
Security commands
xCommand Security Persistency
Set the following features to persistent or non-persistent mode. In non-persistent mode
the information gathered by the specified feature does not persist a reboot of the system.
Persistent mode is the default. This command reboots the system.
Requires user role: ADMIN
USAGE:
xCommand Security Persistency Configurations: Configurations CallHistory:
CallHistory InternalLogging: InternalLogging LocalPhonebook: LocalPhonebook
DHCP: DHCP ConfirmAndReboot: ConfirmAndReboot
where
Configurations: NonPersistent/Persistent
In non-persistent mode, all configurations are set back to default when the system
reboots.
CallHistory: NonPersistent/Persistent
In non-persistent mode call history is deleted when the system reboots.
InternalLogging: NonPersistent/Persistent
In non-persistent mode eventlog is deleted when the system reboots.
LocalPhonebook: NonPersistent/Persistent
In non-persistent mode local phone book is deleted when the system reboots.
DHCP: NonPersistent/Persistent
In non-persistent mode all IP related information is deleted when the system reboots.
ConfirmAndReboot: Yes
Reboots the system.
Standby commands
xCommand Standby Activate
Set the system in standby mode, which turns off the video outputs and put the camera into
sleep mode.
Requires user role: USER
USAGE:
xCommand Standby Activate
xCommand Standby Deactivate
Bring the system out of standby mode.
Requires user role: USER
USAGE:
xCommand Standby Deactivate
xCommand Standby ResetTimer
Set a temporary standby delay. If the system is in standby mode when the reset timer is set,
the system is brought out of standby mode. When left idle for the given delay the system goes
into standby mode. Setting the reset timer does not affect the Standby Delay in the Advanced
configuration menu (or by xConfiguration Standby Delay). Next time this delay is the valid
standby delay.
Requires user role: USER
USAGE:
xCommand Standby ResetTimer Delay: Delay
where
Delay: Integer (1..480)
Set the delay in minutes.
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus

xCommand

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30