D15335.02 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
Copyright © 2016 Cisco Systems, Inc. All rights reserved. 25
Cisco TelePresence MX700 and MX800
API Reference Guide
Example 1: Microphones Mute status.
Terminal query
xStatus Audio Microphones Mute
*s Audio Microphones Mute: Off
** end
Equivalent feedback expression
xFeedback register /Status/Audio/Microphones/Mute
Example 2: Name of all video input connectors.
Terminal query
xConfiguration Video Input Connector Name
*c xConfiguration Video Input Connector 1 Name:
“Na m eA”
*c xConfiguration Video Input Connector 2 Name:
“NameB”
*c xConfiguration Video Input Connector 3 Name:
“NameC”
*c xConfiguration Video Input Connector 4 Name:
“NameD”
*c xConfiguration Video Input Connector 5 Name:
“NameE”
** end
Equivalent feedback expression
xFeedback register /Configuration/Video/Input/
Connector/Name
Example 3: Name of video input connector 3.
Terminal query
xConfiguration Video Input Connector 3 Name
*c xConfiguration Video Input Connector 3 Name:
“NameC”
** end
Equivalent feedback expression
xFeedback register /Configuration/Video/Input/
Connector[@item=’3’]/Name
Feedback mechanism
To build solutions that can reliably keep the state between the
application and the codec synchronized, you need to set up
a notification system to report the changes in the state of the
codec.
The API supports notifications on the following:
• Configuration changes
• Status changes
• Event notifications
These notifications will not be sent unless the user has
explicitly told the codec to do so. The user is required to
subscribe to all the feedback the application needs. This
is done by registering feedback expressions. The way of
registering feedback expressions varies according to the
connection method used.
When using HTTP, the method of handling feedback
differs slightly from what is presented in this section. See
”Feedback from codec over HTTP” on page 29 for more
information.
Feedback expressions
The expression used when registering for feedback is a
variant of the XPath language. This language describes a
way to select nodes from an XML document. CE software
contains three main feedback documents:
The syntax for feedback registering is:
xFeedback register <path>
Never register for all status feedback by issuing
xFeedback register /Status.
It is safe to register for all configuration changes using
xFeedback register /Configuration,
as configuration
changes will most likely not occur that often.
By going through some examples, we can see how this
information can be used to build feedback expressions. A
good way to verify the expressions is to point your browser
to http://<ip-address>/getxml?location=path or to execute
from the terminal, and check that the output
matches the nodes you want feedback on.
WARNING: A codec may give very much feedback,
especially when calls are connected and disconnected.
Therefore, you should only subscribe to the feedback
that you need.
Never register for all status feedback by issuing
xFeedback register /Status. This may give the control
application too much data to handle, which may lead to
sluggish or unpredictable behavior.
Document API command Path
Status xStatus /Status
Configuration xConfiguration /Configuration
Event xEvent /Event
To Next Page
Loading...
Need help?
General
