Cisco TelePresence SX80 User Manual

D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 106
Cisco TelePresence SX80 API Reference Guide
xCommand Camera Ramp
Move the camera in a specified direction. The camera moves at specified speed until a stop
command is issued. In a daisy chain, you need to know the CameraId for the camera you want to
address. Be aware that pan and tilt can be operated simultaneously, but no other combinations.
In the latter case only the first operation specified is executed. For example, if you try to run both
zoom and pan at the same time, only zoom is executed.
NOTE: You must run a stop command to stop the camera, see the example below.
CameraId: Give the camera id.
Pan: Move the camera to the Left or Right, followed by Stop.
PanSpeed: Set the pan speed.
Tilt: Move the camera Up or Down, followed by Stop.
TiltSpeed: Set the tilt speed.
Zoom: Zoom the camera In or Out, followed by Stop.
ZoomSpeed: Set the zoom speed.
Focus: Focus the camera Far or Near, followed by Stop.
Requires user role: USER
Parameters:
CameraId(r): <1..7>
Pan: <Left/Right/Stop>
PanSpeed: <1..15>
Tilt: <Down/Up/Stop>
TiltSpeed: <1..15>
Zoom: <In/Out/Stop>
ZoomSpeed: <1..15>
Focus: <Far/Near/Stop>
Example:
xCommand Camera Ramp CameraId:1 Pan:left PanSpeed:1
xCommand Camera Ramp CameraId:1 Pan:stop
xCommand Camera ReconfigureCameraChain
Reinitialize the daisy chain of cameras and updates the CameraId parameter. The CameraId param-
eter holds information of which camera is sitting in what position in the camera chain.
Requires user role: USER
Example:
xCommand Camera ReconfigureCameraChain
xCommand Camera TriggerAutofocus
Trigger the auto-focus functionality. The camera must support auto-focus functionality. If the
camera is daisy chained, the CameraId is given by its place in the chain.
Requires user role: USER
Parameters:
CameraId(r): <1..7>
Example:
xCommand Camera TriggerAutofocus CameraId:1
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Cisco TelePresence SX80 Specifications

General

Maximum frame rate	60 fps
Supported video modes	720p, 1080p
Video formats supported	H.261, H.262, H.263, H.264, H.265
Supported graphics resolutions	1280 x 720 (HD 720), 1920 x 1080 (HD 1080)
Voice codecs	G.711, G.722, G.722.1, G.729ab
Noise reduction	Yes
HDMI ports quantity	5
DVI-D ports quantity	1
USB 2.0 ports quantity	2
Product color	Silver
Rack capacity	1U
Number of persons	0 person(s)
Analog signal format system	NTSC, PAL
Security algorithms	HTTPS, SSH
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Supported network protocols	SIP, H.323, ISDN, TCP/IP, DHCP, QoS
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Sensor type	-
Image sensor size	- \

Weight and Dimensions

Depth	309.8 mm
Width	442 mm
Height	44 mm
Weight	3650 g