Cisco TelePresence SX80 - About Disconnect Cause Types

D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 230
Cisco TelePresence SX80 API Reference Guide
About disconnect cause types
The following parameters are logged when a call is discon-
nected. The disconnect cause types are used in disconnect
events (xEvent).
CauseValue Proprietary. We recomend the use of CauseType and CauseCode.
CauseType Describes why the call was disconnected. The value space is { OtherLocal, LocalDisconnect,
UnknownRemoteSite, LocalBusy, LocalReject, InsufficientSecurity, OtherRemote, RemoteDisconnect,
RemoteBusy, RemoteRejected, RemoteNoAnswer, CallForwarded, NetworkRejected }
CauseString Describes the Cause Code.
CauseCode The disconnect Cause Codes are defined in SIP and Q.850.
CauseOrigin SIP, Q.850, internal.
Example:
xEvent DisconnectEvent
*e CallDisconnect CauseValue: 1
CauseType: “LocalDisconnect”
CauseString: “”
OrigCallDirection: “outgoing”
RemoteURI: “firstname.lastname@company.com”
CallId: 89
CauseCode: 0
CauseOrigin: SIP
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
Appendices