EasyManuals Logo

Cisco TelePresence SX80 User Manual

Cisco TelePresence SX80
231 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #132 background imageLoading...
Page #132 background image
D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 132
Cisco TelePresence SX80 API Reference Guide
xCommand UserManagement RemoteSupportUser GetState
Retrieves the state of the generated remote support user, if one exists.
Requires user role: ADMIN
Example:
xCommand UserManagement RemoteSupportUser GetState
Video commands
xCommand Video AutoPresentationStart Disable
Not in use in this software version.
Requires user role: ADMIN
Example:
xCommand Video AutoPresentationStart Disable
xCommand Video AutoPresentationStart Enable
Not in use in this software version.
Requires user role: ADMIN
Example:
xCommand Video AutoPresentationStart Enable
xCommand Video Input SetMainVideoSource
Set which input source is the main video source. You can identify the source either by the identifier
of the connector that it is connected to; or by the identifier of the source itself.
This command requires the use of one, and only one, of these parameters: ConnectorId or
SourceId.
ConnectorId: The identifier (ID) of the connector. Connector [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Connector. The connector ID is also printed on the
codec connector panel.
SourceId: The identifier (ID) of the input source. Input Source [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Source.
Requires user role: USER
Parameters:
ConnectorId: <1..5>
SourceId: <1..4>
Example:
xCommand Video Input SetMainVideoSource ConnectorId: 1
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Table of Contents

Other manuals for Cisco TelePresence SX80

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco TelePresence SX80 and is the answer not in the manual?

Cisco TelePresence SX80 Specifications

General IconGeneral
Maximum frame rate60 fps
Supported video modes720p, 1080p
Video formats supportedH.261, H.262, H.263, H.264, H.265
Supported graphics resolutions1280 x 720 (HD 720), 1920 x 1080 (HD 1080)
Voice codecsG.711, G.722, G.722.1, G.729ab
Noise reductionYes
HDMI ports quantity5
DVI-D ports quantity1
USB 2.0 ports quantity2
Product colorSilver
Rack capacity1U
Number of persons0 person(s)
Analog signal format systemNTSC, PAL
Security algorithmsHTTPS, SSH
Ethernet LAN data rates10, 100, 1000 Mbit/s
Supported network protocolsSIP, H.323, ISDN, TCP/IP, DHCP, QoS
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Storage temperature (T-T)-20 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 90 %
Sensor type-
Image sensor size- \
Weight and Dimensions IconWeight and Dimensions
Depth309.8 mm
Width442 mm
Height44 mm
Weight3650 g

Related product manuals