Cisco TelePresence SX80 - Camera status

D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 157
Cisco TelePresence SX80 API Reference Guide
xStatus Call [n] DeviceType
Indicates whether the remote system is a single endpoint or an MCU. Some Cisco endpoints (EX90,
C40, C60, C90, SX20, SX80, MX200 G2, MX300 G2) have built-in MCU capabilities.
Value space of the result returned:
<Endpoint/MCU>
Example:
xStatus Call DeviceType
*s Call 4 DeviceType: Endpoint
** end
xStatus Call [n] AttendedTransferFrom
Shows the CallId for the call the current call was transferred from.
Value space of the result returned:
<Integer>
Example:
xStatus Call 1 AttendedTransferFrom
*s Call 1 AttendedTransferFrom: 1234
** end
Camera status
xStatus Camera
Shows the top level overview of the camera status.
xStatus Camera [n] Connected
Shows if the camera is connected or not.
Value space of the result returned:
<True/False>
Example:
xStatus Camera 1 Connected
*s Camera 1 Connected: True
** end
xStatus Camera [n] HardwareID
Shows the hardware identity of the camera.
Value space of the result returned:
<String>
Example:
xStatus Camera 1 HardwareID
*s Camera 1 HardwareID: "50000000"
** end
xStatus Camera [n] Manufacturer
Shows the manufacturer of the camera.
Value space of the result returned:
<String>
Example:
xStatus Camera 1 Manufacturer
*s Camera 1 Manufacturer: "TANDBERG"
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatusxStatus