Cisco TelePresence SX80 - GPIO Status

D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 172
Cisco TelePresence SX80 API Reference Guide
xStatus Diagnostics Call [n] Channels IncomingAudioChannel [n] Netstat 1 MaxJitter
xStatus Diagnostics Call [n] Channels IncomingVideoChannel [n] Netstat 1 MaxJitter
xStatus Diagnostics Call [n] Channels IncomingDataChannel [n] Netstat 1 MaxJitter
xStatus Diagnostics Call [n] Channels OutgoingAudioChannel [n] Netstat 1 MaxJitter
xStatus Diagnostics Call [n] Channels OutgoingVideoChannel [n] Netstat 1 MaxJitter
xStatus Diagnostics Call [n] Channels OutgoingDataChannel [n] Netstat 1 MaxJitter
Shows the maximum jitter that has been measured during last time interval (5 seconds).
Value space of the result returned:
<Integer>
Example:
xStatus Diagnostics Call 27 Channels OutgoingDataChannel 327 Netstat 1
MaxJitter
*s Diagnostics Call 27 Channels OutgoingDataChannel 327 Netstat 1
MaxJitter: 0
** end
GPIO status
xStatus GPIO Pin [1..4] State
NOTE: This command is not supported on Codec C40.
Shows the current state of each GPIO pin. The default state is High (+12V). When activated the state
is Low (0V).
Value space of the result returned:
<High/Low>
Example:
xStatus GPIO Pin 1 State
*s GPIO Pin 1 State: High
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatusxStatus