Cisco TelePresence SX80 User Manual

D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 114
Cisco TelePresence SX80 API Reference Guide
Logging commands
xCommand Logging ExtendedLogging Start
Turns on the extended logging, which stores more information than regular logging in the log files.
You can determine the duration in seconds. Note that extended logging uses more of your video
system’s resources, and should only be used when troubleshooting an issue.
Requires user role: USER
Parameters:
Duration: <1..600>
Example:
xCommand Logging ExtendedLogging Start Duration: 20
xCommand Logging ExtendedLogging Stop
Stops the logging started with xCommand SystemUnit Diagnostics ExtendedLogging Start.
Requires user role: USER
Example:
xCommand Logging ExtendedLogging Stop
Message commands
xCommand Message Alert Clear
Remove the message which was displayed using the xCommand Message Alert Display command.
This is required when the Duration parameter is not set.
Requires user role: ADMIN
Example:
xCommand Message Alert Clear
xCommand Message Alert Display
Display a message on screen, for a specified duration of time (in seconds). NOTE: If Duration is not
set, the command must be followed by xCommand Message Alert Clear.
Use the xFeedback commands to monitor the feedback from the user. Read more about the xFeed-
back commands in the API introduction section in this guide.
Title: Enter a message title.
Text: Enter the message to be displayed. The <p> and <br> HTML tags will result in line breaks as
normal; any other tags will appear as plain text.
Duration: Set how long (in seconds) the message is to be displayed on the screen. If set to 0 (zero)
the message does not disappear until a xCommand Message Alert Clear message has been sent.
Requires user role: ADMIN
Parameters:
Title: <S: 0, 255>
Text(r): <S: 0, 255>
Duration: <0..3600>
Example:
xCommand Message Alert Display Title: "Message" Text: "The meeting will
end in 5 minutes." Duration: 20
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Cisco TelePresence SX80 Specifications

General

Maximum frame rate	60 fps
Supported video modes	720p, 1080p
Video formats supported	H.261, H.262, H.263, H.264, H.265
Supported graphics resolutions	1280 x 720 (HD 720), 1920 x 1080 (HD 1080)
Voice codecs	G.711, G.722, G.722.1, G.729ab
Noise reduction	Yes
HDMI ports quantity	5
DVI-D ports quantity	1
USB 2.0 ports quantity	2
Product color	Silver
Rack capacity	1U
Number of persons	0 person(s)
Analog signal format system	NTSC, PAL
Security algorithms	HTTPS, SSH
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Supported network protocols	SIP, H.323, ISDN, TCP/IP, DHCP, QoS
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Sensor type	-
Image sensor size	- \

Weight and Dimensions

Depth	309.8 mm
Width	442 mm
Height	44 mm
Weight	3650 g