Cisco TelePresence SX80 User Manual

D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 124
Cisco TelePresence SX80 API Reference Guide
Preset commands
xCommand Preset Activate
Activate one of the stored local presets.
Note that information about all video input sources, and pan, tilt, zoom and focus values for all
cameras are included in the same preset. In contrast, the xCommand Camera Preset commands
applies to individual cameras only.
PresetId: The ID of the preset you want to activate.
Requires user role: USER
Parameters:
PresetId(r): <1..15>
Example:
xCommand Preset Activate PresetId:3
xCommand Preset Clear
Delete a preset.
Note that information about all video input sources, and pan, tilt, zoom and focus values for all
cameras are included in the same preset. In contrast, the xCommand Camera Preset commands
applies to individual cameras only.
PresetId: The ID of the preset you want to delete.
Requires user role: USER
Parameters:
PresetId(r): <1..15>
Example:
xCommand Preset Clear PresetId:3
xCommand Preset Store
Store the connector selections for all video input sources and the current position (pan and tilt),
zoom and focus values for all cameras.
Note that information about all video input sources, and pan, tilt, zoom and focus values for all
cameras are included in the same preset. The system may hold 15 such predefined video input
presets. These presets are available for far end control, i.e. they are referred in the PresetId
parameter of the xCommand FarEndControl Preset Activate command. In contrast, the xCommand
Camera Preset commands applies to individual cameras only. Those presets are not available for far
end control.
PresetId: The ID of this preset.
Type: Not applicable. If you want to ensure that a preset only affects camera positions we recom-
mend that you select Camera.
Description: Enter a description of the camera preset.
Requires user role: USER
Parameters:
PresetId(r): <1..15>
Type(r): <All/Camera>
Description: <S: 0, 255>
Example:
xCommand Preset Store PresetId:3 Type:Camera Description:"Left view"
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Cisco TelePresence SX80 Specifications

General

Maximum frame rate	60 fps
Supported video modes	720p, 1080p
Video formats supported	H.261, H.262, H.263, H.264, H.265
Supported graphics resolutions	1280 x 720 (HD 720), 1920 x 1080 (HD 1080)
Voice codecs	G.711, G.722, G.722.1, G.729ab
Noise reduction	Yes
HDMI ports quantity	5
DVI-D ports quantity	1
USB 2.0 ports quantity	2
Product color	Silver
Rack capacity	1U
Number of persons	0 person(s)
Analog signal format system	NTSC, PAL
Security algorithms	HTTPS, SSH
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Supported network protocols	SIP, H.323, ISDN, TCP/IP, DHCP, QoS
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Sensor type	-
Image sensor size	- \

Weight and Dimensions

Depth	309.8 mm
Width	442 mm
Height	44 mm
Weight	3650 g