Cisco TelePresence SX80 - Page 116

D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 116
Cisco TelePresence SX80 API Reference Guide
xCommand Message Prompt Response
Give a response to the xCommand Message Prompt Display.
Use the xFeedback commands to monitor the feedback from the user. Read more about the xFeed-
back commands in the API introduction section in this guide.
FeedbackId: The FeedbackId corresponds to the FeedbackId given by the xCommand Message
Prompt Display command.
OptionId: The OptionId corresponds to the OptionIds given as possible responses in the xCommand
Message Prompt Display command.
Requires user role: USER
Parameters:
FeedbackId: <S: 0, 255>
OptionId(r): <1..5>
Example:
xCommand Message Prompt Response OptionId: 1
xCommand Message TextLine Clear
Clears the text line which was defined by the xCommand Message TextLine Display command.
Requires user role: ADMIN
Example:
xCommand Message TextLine Clear
xCommand Message TextLine Display
Display a text line on screen. Optionally you can place the text line at a specified location and for a
specified duration of time (in seconds). NOTE: If Duration is not set, the command must be followed
by xCommand Message TextLine Clear.
Text: Enter the text line to be displayed. The <p> and <br> HTML tags will result in line breaks as
normal; any other tags will appear as plain text.
X: Enter the X-coordinate (horizontal) on screen. X=0 is in the upper left corner.
Y: Enter the Y-coordinate (vertical) on screen. Y=0 is in the upper left corner.
Duration: Set how long (in seconds) the text line is to be displayed on the screen. If set to 0 (zero)
the text line is displayed until a xCommand Message TextLine Clear command has been sent.
Requires user role: ADMIN
Parameters:
Text(r): <S: 0, 140>
X: <1..10000>
Y: <1..10000>
Duration: <0..3600>
Example:
xCommand Message TextLine Display Text: "The message to be displayed."
X:500 Y:2000 Duration: 20
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand