D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 42
Cisco TelePresence SX80 API Reference Guide
xConfiguration Conference [1..1] MaxReceiveCallRate
Specify the maximum receive bit rate to be used when placing or receiving calls. Note that this is
the maximum bit rate for each individual call; use the Conference MaxTotalReceiveCallRate setting
to set the aggregated maximum for all simultaneous active calls.
Requires user role: ADMIN
Value space: <64..6000>
Range: Select a value between 64 and 6000 kbps.
Example:
xConfiguration Conference 1 MaxReceiveCallRate: 6000
xConfiguration Conference [1..1] MaxTotalTransmitCallRate
This configuration applies when using a video system's built-in MultiSite feature (optional) to host a
multipoint video conference.
Specify the maximum overall transmit bit rate allowed. The bit rate will be divided fairly among all
active calls at any time. This means that the individual calls will be up-speeded or down-speeded
as appropriate when someone leaves or enters a multipoint conference, or when a call is put on
hold (suspended) or resumed.
The maximum transmit bit rate for each individual call is defined in the Conference
MaxTransmitCallRate setting.
Requires user role: ADMIN
Value space: <64..10000>
Range: Select a value between 64 and 10000.
Example:
xConfiguration Conference 1 MaxTotalTransmitCallRate: 10000
xConfiguration Conference [1..1] MaxTotalReceiveCallRate
This configuration applies when using a video system's built-in MultiSite feature (optional) to host a
multipoint video conference.
Specify the maximum overall receive bit rate allowed. The bit rate will be divided fairly among all
active calls at any time. This means that the individual calls will be up-speeded or down-speeded
as appropriate when someone leaves or enters a multipoint conference, or when a call is put on
hold (suspended) or resumed.
The maximum receive bit rate for each individual call is defined in the Conference
MaxReceiveCallRate setting.
Requires user role: ADMIN
Value space: <64..10000>
Range: Select a value between 64 and 10000.
Example:
xConfiguration Conference 1 MaxTotalReceiveCallRate: 10000
xConfiguration Conference [1..1] VideoBandwidth Mode
Set the conference video bandwidth mode.
Requires user role: ADMIN
Value space: <Dynamic/Static>
Dynamic: The available transmit bandwidth for the video channels are distributed among the
currently active channels. If there is no presentation, the main video channels will use the
bandwidth of the presentation channel.
Static: The available transmit bandwidth is assigned to each video channel, even if it is not active.
Example:
xConfiguration Conference 1 VideoBandwidth Mode: Dynamic
xConfiguration Conference [1..1] VideoBandwidth MainChannel Weight
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel
weight is 2 and the presentation channel weight is 1, then the main channel will use twice as much
bandwidth as the presentation channel.
Requires user role: ADMIN
Value space: <1..10>
Range: 1 to 10.
Example:
xConfiguration Conference 1 VideoBandwidth MainChannel Weight: 5
xConfiguration Conference [1..1] VideoBandwidth PresentationChannel Weight
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel
weight is 2 and the presentation channel weight is 1, then the main channel will use twice as much
bandwidth as the presentation channel.
Requires user role: ADMIN
Value space: <1..10>
Range: 1 to 10.
Example:
xConfiguration Conference 1 VideoBandwidth PresentationChannel Weight: 5
To Next Page
Loading...
Need help?
General
Weight and Dimensions
