D15107.0 5 Codec SX80 API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 58
Cisco TelePresence SX80 API Reference Guide
xConfiguration NetworkServices SNMP CommunityName
Enter the name of the Network Services SNMP Community. SNMP Community names are used
to authenticate SNMP requests. SNMP requests must have a password (case sensitive) in order
to receive a response from the SNMP Agent in the codec. The default password is "public". If
you have the Cisco TelePresence Management Suite (TMS) you must make sure the same SNMP
Community is configured there too. NOTE: The SNMP Community password is case sensitive.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example:
xConfiguration NetworkServices SNMP CommunityName: "public"
xConfiguration NetworkServices SNMP SystemContact
Enter the name of the Network Services SNMP System Contact.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example:
xConfiguration NetworkServices SNMP SystemContact: ""
xConfiguration NetworkServices SNMP SystemLocation
Enter the name of the Network Services SNMP System Location.
Requires user role: ADMIN
Value space: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example:
xConfiguration NetworkServices SNMP SystemLocation: ""
xConfiguration NetworkServices SSH Mode
SSH (or Secure Shell) protocol can provide secure encrypted communication between the codec
and your local computer.
Requires user role: ADMIN
Value space: <Off/On>
Off: The SSH protocol is disabled.
On: The SSH protocol is enabled.
Example:
xConfiguration NetworkServices SSH Mode: On
xConfiguration NetworkServices SSH AllowPublicKey
Secure Shell (SSH) public key authentication can be used to access the codec.
Requires user role: ADMIN
Value space: <Off/On>
Off: The SSH public key is not allowed.
On: The SSH public key is allowed.
Example:
xConfiguration NetworkServices SSH AllowPublicKey: On
xConfiguration NetworkServices CTMS Mode
This setting determines whether or not to allow multiparty conferences controlled by a Cisco
TelePresence Multipoint Switch (CTMS).
Video systems are able to initiate or join non-encrypted multiparty conferences controlled by CTMS
version 1.8 or later. Encrypted conferences are supported as from software versions CTMS 1.9.1.
Encryption is addressed in the NetworkServices CTMS Encryption setting.
Requires user role: ADMIN
Value space: <Off/On>
Off: Multiparty conferencing via CTMS is prohibited.
On: Multiparty conferencing via CTMS is allowed.
Example:
xConfiguration NetworkServices CTMS Mode: On
xConfiguration NetworkServices CTMS Encryption
This setting indicates whether or not the video system supports encryption when participating in a
multiparty meeting controlled by a Cisco TelePresence Multipoint Switch (CTMS).
CTMS allows three security settings for meetings: non-secure (not encrypted), best effort
(encrypted if all participants support encryption, otherwise not encrypted) and secure (always
encrypted).
Requires user role: ADMIN
Value space: <Off/BestEffort>
Off: The video system does not allow encryption and therefore cannot participate in a secure
CTMS meeting (encrypted). When participating in a best effort CTMS meeting, the meeting will be
downgraded to non-secure (not encrypted).
BestEffort: The video system can negotiate encryption parameters with CTMS and participate in a
secure CTMS meeting (encrypted). Do not use this value if the CTMS version is older than 1.9.1.
Example:
xConfiguration NetworkServices CTMS Encryption: Off
To Next Page
Loading...
Need help?
General
Weight and Dimensions
