EasyManuals Logo

Cisco WS-CE500 User Manual

Cisco WS-CE500
240 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #112 background imageLoading...
Page #112 background image
Firewall Configuration
Configuring Firewall Rules to Control Inbound and Outbound Traffic
Cisco SA500 Series Security Appliances Administration Guide 112
4
Service: Choose from a list of common services or a custom defined service.
For more information, see Appendix B, “Standard Services and Creating
Custom Services, page 104.
Action: You can choose to block or to allow and to apply the rule always or
only on a specified schedule. Choose BLOCK always, ALLOW always,
BLOCK by schedule, or ALLOW by schedule.
Select Schedule: If you choose one of the “by schedule” actions, choose a
schedule from the list.
For more information about schedules, see Creating Schedules for a
Firewall Rules, page 105.
Source Hosts: You can apply the rule to all users or you can specify users
by entering an IP address or address range.
- If you choose Single Address, enter an IP address in the From field.
- If you choose Address Range, enter the first address in the From field and
enter the last address in the To field.
Destination Hosts (available only if the traffic flow is from DMZ to LAN): You
can apply the rule to all users or you can specify users by entering an IP
address or address range.
- If you choose Single Address, enter an IP address in the From field.
- If you choose Address Range, enter the first address in the From field and
enter the last address in the To field.
Local Server: Shows the IP address of the local server (only applies to IPv4
Firewall rules.)
Log: You can choose whether or not to log the packets for this rule. Click
Never if you do not want to log the packets, or click Always to log the
packets.
STEP 4 For a WAN-to-LAN or a WAN-to-DMZ rule, enter the following information in the
Destination NAT Settings area:
Internal IP Address: Enter the IP address of the server that is hosting the
service.
Enable Port Forwarding: Check the box to forward traffic to a particular
port.
Translate Port Number: If you enabled port forwarding, enter the port
number that will be the destination for the forwarded traffic.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco WS-CE500 and is the answer not in the manual?

Cisco WS-CE500 Specifications

General IconGeneral
BrandCisco
ModelWS-CE500
CategoryNetwork Hardware
LanguageEnglish

Related product manuals