ComAp InteliCompact NT

InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
123
SWITCH
OUTPUT
OFF
ON
OFF
ON
ANALOG VALUE
LEVEL OFF LEVEL ON
LEVEL ON LEVEL OFF
ANALOG VALUE
SWITCH
OUTPUT
LEVEL ON > LEVEL OFF
LEVEL ON < LEVEL OFF
6.18 Power switch
There is also one switch assigned to the gen-set active power, which is called the Power switch. The
setpoints for on and off level adjustment are located in the setpoint group Analog switches. The output
is provided as the binary output Power switch.
The behaviour of the switch depends on the adjustment of the setpoints.
SWITCH
OUTPUT
OFF
ON
OFF
ON
ANALOG VALUE
LEVEL OFF LEVEL ON
LEVEL ON LEVEL OFF
ANALOG VALUE
SWITCH
OUTPUT
LEVEL ON > LEVEL OFF
LEVEL ON < LEVEL OFF
6.19 Regulation loops
The following table shows which setpoints influence regulation in which situation.
6.19.1 SPtM
SPEED REGULATOR OUTPUT FOR SINGLE GEN-SET APPLICATION
ISLAND
LOADED ISLAND
PARALLEL TO MAINS
LOADED IN PARALLEL
TO MAINS
Running
GCB opened
GCB closed
MCB opened
Synchronizing
GCB closed
MCB closed