ComAp InteliCompact NT

InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
14
3 Installation
3.1 Mounting
The controller is to be mounted onto the switchboard door. The requested cut-out size is 175x115 mm.
Use the screw holders delivered with the controller to fix the controller into the door as described in the
pictures below. Recommended tightening torque is 0,15 – 0,2 Nm.
3.2 Package contents
The package contains:
 Controller
 Mounting holders
 Terminal blocks
NOTE:
The package does not contain a communication module. The required module should be ordered
separately.