InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
The phase shift between the gen-set and the mains voltage.
16.2.5 Group: Pwr Management
Value: Actual Reserve
kW or % (depends on #PowerMgmtMode setpoint)
#PowerMgmtMode setpoint is set to ABS(kW):
This value represents the difference between the current load of the group
and the nominal capacity of the currently loaded gen-sets.
#PowerMgmtMode setpoint is set to REL(%):
This value represents the difference between the actual relative load of the
group and 100%.
= Running NomPwr and
= Running ActPwr.
Sum of active power of all gen-sets within the group that are connected to
the bus and are performing the power management, i.e. that are in AUT
mode and have power management enabled.
To Next Page
Loading...
Need help?
General
