InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
Limits and units depend on analog input configuration
This setpoint can be used to "calibrate" the analog input 2 of the extension
module IG-IOM or IGS-PTM, i.e. shift the measured value on the analog
input with a constant. The setpoint (constant) is always added to the
measured analog value.
NOTE:
It is recommended to perform the calibration under operating conditions, i.e.
perform a coolant temperature sensor calibration when the engine is warm,
not cold.
Limits and units depend on analog input configuration
This setpoint can be used to “calibrate” the analog input 3 of the extension
module IG-IOM or IGS-PTM, i.e. shift the measured value on the analog
input with a constant. The setpoint (constant) is always added to the
measured analog value.
NOTE:
It is recommended to perform the calibration under operating conditions, i.e.
perform a coolant temperature sensor calibration when the engine is warm,
not cold.
Limits and units depend on analog input configuration
This setpoint can be used to “calibrate” the analog input 4 of the extension
module IG-IOM or IGS-PTM, i.e. shift the measured value on the analog
input with a constant. The setpoint (constant) is always added to the
measured analog value.
NOTE:
It is recommended to perform the calibration under operating conditions, i.e.
perform a coolant temperature sensor calibration when the engine is warm,
not cold.
To Next Page
Loading...
Need help?
General
