InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
Alarm: High Water Temperature 2
This alarm indicates that the water temperature is higher than the set red
alarm of relevant AI (Water Temp).
Alarm: Low Oil Pressure 1
This alarm indicates that the oil pressure is lower than the set yellow alarm
of relevant AI (Oil Press).
Alarm: Low Oil Pressure 2
This alarm indicates that the oil pressure is lower than the set red alarm of
relevant AI (Oil Press).
Engine stop fail indication. Stop fail means that the engine does not reach
“still engine” state within Engine params: Stop time.
NOTE:
“Still engine” conditions:
– Engine speed (RPM) = 0 and
– AI: Oil press < Starting POil and
– D+ terminal is not active and