InteliDrive DCU Industrial 3.4.0 Global Guide
102
Engine commands and Statistics protection
Commands (Engine Cmd) password protection protects Start, Horn reset, Fault reset commands from
controller front panel buttons, remote displays, Modbus line or InteliMonitor.
Selected Command password level 0, 1, 2, 3 is valid for all engine commands except of Stop. Stop command is
password protected separately by “Engine Stop” option.
Separately can be also protected statistic commands: ClearStatistics, SetSucc starts, EngRun hours,
SetUnsuc starts.
To set commands protection from DriveConfig:
1. Open DriveConfig
2. Select Commands window
3. Set Password = 0 (no protection) or level 1 or 2 or 3
Note: Engine commands password protection works according to the description above from firmware version
ID DCU MARINE 2.1 and firmware versions of remote displays listed below. In older firmware versions “Engine
Cmd” group contains also Stop command, commands from ID-DCU Industrial local panel (buttons directly on
the controller) were not password protected in older versions.
InteliVision 5 CAN (Backlit) – from 1.3
InteliVision 8 (Marine) – depends on screen configuration in archive of ID-DCU Industrial controller. Default
archives for ID-DCU Industrial version 2.1 and higher support independent password protection of Stop
command according to description above.
Note: All setpoints below can be modified from Remote panel or InteliMonitor as well.
To Next Page
Loading...
