ComAp InteliDrive DCU Industrial - Page 103

InteliDrive DCU Industrial 3.4.0 Global Guide
103
Basic settings
Setpoint group Basic settings Related FW 3.4.0
Range [units] [-]
Default value ID
Force value
Alternative config
Step [-]
Comm object 8637 Related applications AS, SS
Description
User defined name, used for InteliDrive controller identification with remote connection.
Engine name is max 14 characters long and have to be entered manually using InteliMonitor software.
Note: Engine name is not changed when new archive is loaded. Check Engine name after firmware
upgrade.
Engine Name
6 back to List of setpoints
Setpoint group Basic settings Related FW 3.4.0
Range [units] [-]
Default value OFF
Force value
Alternative config
Step [-]
Comm object 8315 Related applications AS, SS
Description
Mode ID [OFF, RUN ]
Equivalent to Controller mode changes by Mode→ or ←Mode buttons.
Mode ID
6 back to List of setpoints
Setpoint group Basic settings Related FW 3.4.0
Range [units] 1 .. 500 [-]
Default value 120
Force value
Alternative config
Step 1
Comm object 8252 Related applications AS, SS
Description
Number of teeth on the engines flywheel for the pick-up. Setpoint (RPM pickup measuring) is ignored
when RPM is received via J1939.
Gear Teeth
6 back to List of setpoints