InteliDrive DCU Industrial 3.4.0 Global Guide
114
Setpoint group
Communication
Settings
Related FW 3.4.0
Range [units] [19200, 38400, 57600, 115200] [bps]
Default value 38400 bps
Force value
Alternative config
Step [-]
Comm object 24340 Related applications AS, SS
Description
The setpoint adjusts communication speed of the RS485 interface when RS485 Mode (page 113) is set to
STANDARD.
RS485 TermCSpd
6 back to List of setpoints
Setpoint group
Communication
Settings
Related FW 3.4.0
Range [units] [DISABLED, ENABLED]
Default value ENABLED
Force value
Alternative config
Step [-]
Comm object 11024 Related applications AS, SS
Description
This setpoint is used to enable/disable evaluation of collisions of virtual shared peripherial modules. A
collision means that there is more than one source (shared outputs module) active on the CAN2 bus.
Note: In certain situations multiple sites with bus tie breakers may need to have more shared outputs
sources as the CAN bus line is in some points interrupted according to bus tie breakers position.
Normally a collision would be indicated if there were more sources on the bus and this setpoint can be
used to disable the evaluation of collisions in this special case.
SHxOcol Detect
6 back to List of setpoints
To Next Page
Loading...
