ComAp InteliDrive DCU Industrial - Page 154

InteliDrive DCU Industrial 3.4.0 Global Guide
154
Setpoint group Date/Time Related FW 3.4.0
Range [units] [DISABLED, WINTER, SUMMER, WINTER-S, SUMMER-S]
Default value DISABLED
Force value
Alternative config
Step [-]
Comm object 8727 Related applications AS, SS
Description
The setpoint is used to select mode of automatic time change.
EST (European Summer Time) started last Sunday in March. EST ends last Sunday in October.
Southern hemisphere is roughly the reverse. Time change depends on location and can vary in 8 weeks
time.
DISABLED The automatic change to daylight saving time and back is disabled.
WINTER
The automatic change is enabled, the current season is winter and the controller is
located in the northern hemisphere.
SUMMER
The automatic change is enabled, the current season is summer and the controller is
located in the northern hemisphere.
WINTER-S
The automatic change is enabled, the current season is winter and the controller is
located in the southern hemisphere.
SUMMER-S
The automatic change is enabled, the current season is summer and the controller is
located in the southern hemisphere.
SummerTimeMod
6 back to List of setpoints
Setpoint group Date/Time Related FW 3.4.0
Range [units] [DISABLED, ENABLED]
Default value DISABLED
Force value
Alternative config
Step [-]
Comm object 24217 Related applications AS, SS
Description
The setpoint is used to enable Time synchronization function with InteliGen-NT and InteliSys-NT
controllers over CAN2 bus.
The synchronization is just unidirectional from InteliGen-NT or InteliSys-NT controller into InteliDrive
DCU Industrial, not vice versa.
EnTimeSync
6 back to List of setpoints