ComAp InteliDrive DCU Industrial - Page 191

InteliDrive DCU Industrial 3.4.0 Global Guide
191
Related FW 3.4.0 Related applications AS, SS
Comm object 2
Description
The output is closed if there is a communication failure with the RS485 interface.
The timeout for communication failure is 5 seconds.
Note: When communication with any terminal is lost, the LBO: HORN (PAGE 193) is closed and a history
record is written. This history record can be enabled / disabled by the setpoint LB/UART Log (page
111).
AccessLockCOM2
6 back to List of LBO
Related FW 3.4.0 Related applications AS, SS
Comm object 2
Description
The output is closed if there is a communication failure with CAN2 with address #1.
The timeout for communication failure of CAN2 interface is adjusted by the setpoint CAN2 Timeout (page
110).
Note: When communication with any terminal is lost, the LBO: HORN (PAGE 193) is closed and a history
record is written. This history record can be enabled / disabled by the setpoint LB/UART Log (page
111).
AcsLockCAN2(1)
6 back to List of LBO
Related FW 3.4.0 Related applications AS, SS
Comm object 2
Description
The output is closed if there is a communication failure with CAN2 with address #2.
The timeout for communication failure of CAN2 interface is adjusted by the setpoint CAN2 Timeout (page
110).
Note: When communication with any terminal is lost, the LBO: HORN (PAGE 193) is closed and a history
record is written. This history record can be enabled / disabled by the setpoint LB/UART Log (page
111).
AcsLockCAN2(2)
6 back to List of LBO