expansion base
system board is
properly seated
in the top
cover, then
tighten the
screws in the
proper sequence
(Section 9.13).
3. If docking a Compaq
LTE Elite, loosen
the system board
screws in the
computer and
retighten them in
the proper sequence
(Section 4.17).
===========================================================================
Problem Probable Cause Recommended Action(s)
===========================================================================
The top cover is bowing Check for bowing in
up. the top cover. *** If
bowed, complete the
following steps as
required:
1. Ensure that the
drive cage spacer
is installed
properly (Section
9.16). Reinstall
the spacer if
improperly
installed or
missing.
2. Replace the top
cover.
--------------------------------------------------
Defective docking Replace the docking
mechanism. mechanism.
---------------------------------------------------------------------------
The motor engages but A non-supported computer Ensure that the
cycles the computer in is being used. computer is a Compaq
and out. LTE Lite or a Compaq
LTE Elite. ****
----------------------
The reflectors on the 1. Ensure that the
plastic gear are blocked white reflectors on
or missing. the plastic gear
are present and are
clear of debris.
2. Replace the docking
mechanism.
--------------------------------------------------
The motor position sensor 1. Ensure that the two
on the expansion base small lenses on the
system board is blocked motor position
or defective. sensor are clear of
debris.
2. Ensure that the
motor position
To Next Page
Loading...
Need help?
General