EasyManuals Logo
Home>Compaq>Laptop>LTE Elite

Compaq LTE Elite User Manual

Compaq LTE Elite
387 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #222 background imageLoading...
Page #222 background image
replace the bottom
or top cover
(whichever
applies).
--------------------------------------------------
Plastic latches are worn Ensure that the
off of the bottom cover. plastic latches are
not worn off. If they
are, replace the
bottom cover.
===========================================================================
Table 7-4. Hardware Installation Problems
===========================================================================
Problem Probable Cause Recommended Action(s)
===========================================================================
The drive or optional The drive or optional Use only supported
device does not fit in device is not supported. drives or optional
the drive bay. devices (Table 8-10)
that meet the maximum
drive bay length
requirement listed in
Section 10.1.
--------------------------------------------------
Drive cage is bent. 1. Determine if there
are irregularities
in the drive cage
or if there are
obstructions.
Straighten the
drive cage if
possible.
2. Replace the drive
cage.
---------------------------------------------------------------------------
A new device is not The power switch of the Turn off the system,
recognized as part of new external device was then turn on the
the computer system. not turned on before the external device, then
system was turned on. turn on the system to
integrate the new
device.
--------------------------------------------------
Computer Setup has to be Run Computer Setup.
run to configure the new
device.
--------------------------------------------------
The signal cable or power Ensure that all
cable of the new device is cables are properly
loose or disconnected. and securely
connected.
--------------------------------------------------
The switch settings on the Correct the switch
vertical circuit board are settings on the
incorrect. vertical circuit
board.
--------------------------------------------------
More than one optional Correct the IRQ
device has the same settings for the
interrupt request (IRQ) optional devices that
setting. are conflicting.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Compaq LTE Elite and is the answer not in the manual?

Compaq LTE Elite Specifications

General IconGeneral
BrandCompaq
ModelLTE Elite
CategoryLaptop
LanguageEnglish

Related product manuals