sensor is aligned
straight over its
holes in the
expansion base
system board.
3. Replace the
expansion base
system board.
---------------------------------------------------------------------------
*** When verifying whether the top cover is bowed up, note that the
computer should ride on the outer edges of the docking bay of the
expansion base and not in the center area. If the center area has
scuff marks or if the computer can rock from side to side while in the
docking bay, this indicates that the top cover is bowed up.
**** Compaq LTE Lite must use the SmartStation Adapter to dock in the
Compaq SmartStation (Section D.1).
===========================================================================
Problem Probable Cause Recommended Action(s)
===========================================================================
The motor engages, A foreign object is Ensure that there is
but the docking interfering. no foreign object
mechanism doesn't between the
pull the computer computer and the
towards the expansion expansion base.
base.
--------------------------------------------------
The top cover is bowing Check for bowing in
up. the top cover. *** If
bowed, complete the
following steps as
required:
1. Ensure that the
drive cage spacer
is installed
properly (Section
9.16). Reinstall
the spacer if
improperly
installed or
missing.
2. Replace the top
cover.
--------------------------------------------------
The docking mechanism 1. Ensure that the
sled is defective. docking mechanism
sled is functioning
properly.
2. Replace the docking
mechanism.
===========================================================================
Table 7-2b. Docking/Undocking Problems (Undocking)
===========================================================================
Problem Probable Cause Recommended Action(s)
===========================================================================
The motor does not No power. 1. Ensure that the
engage, and no beeps power cord is
are emitted. properly connected
to the expansion