Table 2-10. Tape Drive Computer Checkup Error Codes
===========================================================================
Error Code Description Recommended Action
===========================================================================
1900 - xx Tape ID failed. The following steps apply to
1900 - xx through 1906 - xx error
1901 - xx Tape servo write codes:
failed.
1. Replace the tape cartridge.
1902 - xx Tape format failed. 2. Check the switch settings on
the adapter board.
1903 - xx Tape drive sensor test 3. Check and/or replace the
failed. signal cable.
4. Replace the tape adapter board
1904 - xx Tape BOT/EOT test (if applicable).
failed. 5. Replace the tape drive.
6. Replace the system board.
1905 - xx Tape read test failed.
1906 - xx Tape write/read/
compare test failed.
===========================================================================
Table 2-11. Video Computer Checkup Error Codes
===========================================================================
Error Code Description Recommended Action
===========================================================================
2402 - xx Video memory test The following step applies to
failed. 2402 - xx through 2480 - xx error
codes:
2403 - xx Video attribute test
failed. Replace the system board.
2404 - xx Video character set
test failed.
2405 - xx Video 80 x 25 mode
9 x 14 character cell
test failed.
2406 - xx Video 80 x 25 mode
8 x 8 character cell
test failed.
2408 - xx Video 320 x 200 mode
color set 0 test
failed.
2409 - xx Video 320 x 200 mode
color set 1 test
failed.
2410 - xx Video 640 x 200 mode
test failed.
2412 - xx Video gray scale test
failed.
2414 - xx Video white screen