EasyManua.ls Logo

Compaq LTE Elite - Docking Mechansim

Compaq LTE Elite
387 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9.12 Docking Mechansim
NOTE:Do not lubricate the docking mechanism. To ensure freedom of movement
in the docking mechanism sled, manually move the sled when a computer
is not docked.
To remove the docking mechanism, complete the following steps:
1. Remove the bottom cover (Section 9.6).
2. Remove any expansion boards that are installed (Section 9.8).
3. Remove the expansion board cage (Section 9.9).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The terminals on the docking mechanism motor and computer status sensor are
fragile. To avoid damaging the terminals, handle the cables carefully when
removing and replacing them.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
4. Disconnect the two cables from the docking mechanism motor (Figure 9-17).

Table of Contents

Related product manuals