(Section 9.18).
3. Reassemble the
expansion base,
allowing the eject
switch board to
hang out from the
side of the unit
for test purposes.
4. Ensure that the
operating
condition of the
expansion base is
such that the
eject switch is
functional.
5. Press the eject
button that is
mounted directly
on the eject
switch board.
6. If the expansion
base undocks the
computer properly,
replace the
plastic eject
switch components.
7. If the expansion
base does not
undock the
computer properly,
replace the eject
switch cable
harness.
===========================================================================
Problem Probable Cause Recommended Action(s)
===========================================================================
The eject switch cable 1. Replace the eject
harness or harness switch cable
extension cable is harness.
defective. 2. Replace the
harness extension
cable.
---------------------------------------------------------------------------
The motor does not The expansion base system Replace the expansion
engage, and no beeps board is defective. base system board.
are emitted.
--------------------------------------------------
The computer status sense Check to see if the
pads on the bottom of the sense tabs are bent
computer are not making or deformed. If so,
contact with the sense replace the docking
tabs on the docking mechanism.
mechanism sled.
---------------------------------------------------------------------------
The motor does not The expansion base is Ensure that the
engage but there is locked. keylock is unlocked
an immediate beep. and that the keylock
switch on the top
cover is not stuck.
If the keylock
To Next Page
Loading...
Need help?
General