switch components
(Section 9.18).
3. Reassemble the
expansion base,
allowing the power
switch board to
hang out from the
side of the unit
for test purposes.
4. Ensure that the
operating
condition of the
expansion base is
such that the
power switch is
functional.
5. Press the power
button that is
mounted directly
on the power
switch board.
6. If the expansion
base and computer
power up, replace
the plastic power
switch components.
7. If the expansion
base and computer
do not power up,
replace the
power switch cable
harness.
--------------------------------------------------
The power switch cable 1. Reseat the cable
harness or harness harness.
extension cable is not 2. Replace the cable
making a complete harness.
connection or is 3. Reseat the harness
defective. extension cable.
4. Replace the
harness extension
cable.
--------------------------------------------------
The expansion base system Replace the
board is defective. expansion base system
board.
---------------------------------------------------------------------------
When a Compaq LTE The power button on the 1. Remove the
Elite is docked and computer is not being computer from the
the power switch on activated. expansion base and
the computer is attempt to power
pressed, the expansion on the computer by
base and the computer itself.
do not power on, no 2. If the computer
beep is emitted, and does not power on
there is no LED by itself, the
activity on either the problem is with
expansion base or the the the computer
computer. (Table 2-26).
---------------------------------------------------------------------------
To Next Page
Loading...
Need help?
General