no setting for
single, set the
jumper switches to
master.
---------------------------------------------------------------------------
Time-Out on Disk 1 The power or signal cable Ensure that the power
Secondary controller is not properly connected and signal cables are
EXTDISK not installed to the drive. properly and securely
connected.
--------------------------------------------------
Incorrect version of Install the version
EXTDISK.SYS. of EXTDISK.SYS
included with the
SmartStation Adapter.
--------------------------------------------------
There is an interrupt Eliminate the IRQ
request (IRQ) conflict. conflict by
completing the
following steps as
required:
1. Change the switch
2 setting on the
vertical circuit
board.
2. Change the
interrupt setting
used by the
optional device
so that it does
not conflict with
the setting used
by the IDE hard
drive.
--------------------------------------------------
The jumpers on the drive If only one IDE hard
are improperly set. drive is in the
expansion base, set
the jumper switches
on the drive to
single. If there is
no setting for
single, set the
jumper switches to
master.
--------------------------------------------------
The power cable or signal Determine if the
cable connected to the power and/or signal
drive is defective. cable is defective by
connecting another
cable.
===========================================================================
To Next Page
Loading...
Need help?
General