following steps:
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To avoid damage to the PCMCIA connector when undocking, be sure to remove
any PCMCIA cards and cables that do not allow the PCMCIA compartment door
to close fully.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
1. Remove any cable or card that does not allow the PCMCIA door to close
fully.
2. Save and close all open files.
3. Turn off the system.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To avoid data loss from a computer reboot, be sure that the system is
turned off before undocking the computer.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
4. Pull the docking lever toward the computer (Figure D-18).
To Next Page
Loading...
Need help?
General