The Configuration and Diagnostics menu is displayed.
4. Select Computer Checkup (TEST) from the Configuration and Diagnostics
menu.
The Computer Checkup options menu is displayed.
5. Select View Device List.
A list of the installed hardware devices is displayed.
NOTE: Computer Checkup may not detect non-Compaq devices.
6. Verify that Computer Checkup correctly detected the installed devices.
If the list is correct, select OK. The Computer Checkup option menu is
displayed again.
If the list is incorrect, verify that the new devices are installed
properly.
7. Select one of the following from the Computer Checkup options menu:
o Quick Check Diagnostics - This option runs a quick, general test on
each device with a minimal number of prompts. If errors occur, they
are displayed when the testing is complete.
o Automatic Diagnostics - This option runs an unattended, maximum test
of each device with minimal prompts. You can choose how many times to
run the tests, to stop on errors, or to print or file a log of
errors.
o Prompted Diagnostics - This option allows maximum control over the
device testing process. You can choose attended or unattended
testing, decide to stop on errors, or choose to print or file a log
of errors.
8. Follow the instructions on the screen as the diagnostic tests are run
on the devices.
When the testing is complete, the Computer Checkup options menu is
displayed again.
9. Exit the test option menu.
10. Exit the Configuration and Diagnostics menu.
NOTE: Exiting the Configuration and Diagnostics menu restarts the
computer and saves your changes.
11. Look up in the "Computer Checkup Error Codes" tables any error codes
that were displayed, and take the recommended action.
To Next Page
Loading...
Need help?
General